Suburban 1/2 Ton 2WD V8-5.3L VIN Z Flex Fuel (2006)
3. Remove the screws from the blower motor (1).
4. Remove the blower motor (1) from the HVAC module (3).
5. Remove the retainer from the blower motor impeller. Discard the retainer.
6. Remove the blower motor impeller from the blower motor (1).
INSTALLATION PROCEDURE
1. Install the blower motor impeller to the blower motor (1).
2. Install the new retainer to the blower motor impeller.
3. Install the blower motor (1) to the HVAC module (3).
4. Install the screws to the blower motor (1).
NOTE: Refer to Fastener Notice in Service Precautions.
Tighten the screws to 2 N.m (18 lb in).
5. Connect the electrical connector (2) to the blower motor (1).
6. Install the sound insulator panel.
Blower Motor Replacement - Auxiliary
BLOWER MOTOR REPLACEMENT - AUXILIARY
REMOVAL PROCEDURE
1. Remove the right rear quarter trim panel.
2. Disconnect the electrical connectors.
3. Remove the blower motor screws.
4. Remove the blower motor (1) from the auxiliary HVAC module (2).
5. Remove the retaining clip from the fan cage.
6. Remove the fan cage from the blower motor.
INSTALLATION PROCEDURE
