Suburban 1/2 Ton 2WD V8-5.3L VIN Z Flex Fuel (2006)
3. Install the positive cable to the starter.
NOTE: Refer to Fastener Notice in Service Precautions.
4. Install the positive cable nut (1).
Tighten the nut to 9 N.m (80 lb in).
5. Install the starter lead (2) to the starter.
6. Install the starter lead nut (3).
Tighten the nut to 3.4 N.m (30 lb in).
7. Position the starter into place.
8. Install the starter bolts.
Tighten the bolts to 50 N.m (37 lb ft).
9. Connect the oil level sensor electrical connector.
10. If equipped with 4WD, position the front axle mounting bracket bolt until the bolt is fully seated.
11. If equipped with 4WD, install the front axle mounting bracket nuts.
