Suburban 1/2 Ton 2WD V8-5.3L VIN Z Flex Fuel (2006)
1. Using the J 38185 install to link rod to the ball stud on the sensor lever and the frame bracket.
2. Install the ESC sensor to the vehicle.
15 Series
Rear Position Sensor Replacement - Electronic Suspension - Left (15 Series)
Removal Procedure
1. Raise and support the vehicle. Refer to Vehicle Lifting.
2. Remove the wheel and tire assembly from the vehicle.
3. Disconnect the sensor harness connector from the vehicle harness connector.
4. Remove the bolt from the electronic suspension control (ESC) sensor link bracket.
5. Spread the bracket open until the bracket can be removed from the upper control arm.
6. Remove the bolts from the frame.
7. Remove the position sensor from the vehicle.
Installation Procedure
1. Install the position sensor on the vehicle.
2. Install the bolts to the frame.
^
Tighten the bolts to 12 Nm (106 inch lbs.).
Notice: Refer to Fastener Notice in Service Precautions.
