Suburban 1/2 Ton 2WD V8-5.3L VIN Z Flex Fuel (2006)
6. Inspect the shaft (6) for bent or damaged threads.
7. Clean the tapered surface of the steering knuckle (1).
Installation Procedure
1. Lubricate the tie rod threads with chassis lubricant. Refer to Fluid and Lubricant Recommendations.
2. Install the tie rod end (4) to the shaft (6).
3. Install the outer tie rod ball stud (3) to the steering knuckle (1).
4. Install the new prevailing torque nut (2) to the outer tie rod ball stud (3).
^
Tighten the nut to 50 Nm (37 ft. lbs.) for 15 series vehicles.
^
Tighten the nut to 65 Nm (48 ft. lbs.) for 25/35 series vehicles.
5. Adjust the front toe.
Tie Rod Replacement - Inner
Tie Rod Replacement - Inner
^
Tools Required
-
J 34028 Inner Tie Rod Wrench
Removal Procedure
1. Raise the vehicle. Refer to Lifting and Jacking the Vehicle.
2. Remove the engine protection shield, if equipped.
3. Remove the outer tie rod end.
