Suburban 1/2 Ton 2WD V8-5.3L VIN Z Flex Fuel (2006)
12. Position the inboard end (tripot end) of the halfshaft assembly into the base of the J 36652-98 for the 1500 models or J 36652-1 for the 2500, 3500
and Hummer H2 models.
13. Install the top half of the J 36652-98 for the 1500 models or J 36652-1 for the 2500, 3500 and HUMMER H2 models.
14. Align the swage ring (2) and the swage ring clamp.
15. Insert the bolts.
^
Hand tighten the bolts until the bolts are snug.
16. Align the following during this procedure:
^
The tripot boot (3)
^
The tripot housing (1)
^
The swage ring (2)
^
Tighten each bolt 180° at a time. Alternate between the bolts until both sides of the top half of the tool touch the bottom half .
^
Loosen the bolts and remove the halfshaft assembly from the tool.