chevrolet Workshop Repair Guides

Chevrolet Workshop Service and Repair Manuals

Rear Inner Headliner Roof Molding - Sagging|Page 546 > < Rear Inner Headliner Roof Molding - Sagging|Page 544
Page 14
background image

B.

If the cupping or wear is severe, and/or the cross grooves in the outside shoulder are not visible, tire replacement may be necessary. Tire
replacement, if required, will be made with the same brand and type tire as original equipment. These tires will be furnished on a "direct
billed" basis to the dealer. Replacement tires must be obtained direct from the tire company by calling one of the following toll-free numbers:

Firestone

- (216) 379-7096 (collect)

General

- 1-800-TIRE-FIX

Goodyear

- 1-800-TIRE-TEC

Uniroyal

- 1-800-231-5893 (EXCEPT TEXAS)
1-800-833-5906 (TEXAS)

Dealers must supply owner's name, VIN, mileage, dealer code, tire make, size and description (i.e., Whitewall, Brand Name, etc.)

A maximum of two (2) tires per vehicle will be provided on a "one time only" basis at no charge to the customer for the first 12,000 miles or 12
months.

2.

A. On Caprice and Monte Carlo models, whether tires are replaced or rotated, front alignment must be measured. For the best tire wear, reset toe
to zero. Camber and caster should be set to specification.

B.

On Celebrity models, install rear axle shim kit, P/N 14094481, as explained in Chevrolet Dealer Service Bulletin 86-23. This will reduce
rear toe.

C.

On "M" van, "G" van, "C/K" trucks, and S/T trucks, whether tires are replaced or rotated, front alignment must be measured. For best tire
wear, reset toe to zero. Camber and caster should be set to specification.

TIRE ROTATION PATTERN

D.

IMPORTANT ON ALL VEHICLES To further help minimize tire wear, stress the importance of regular tire rotation to the owner. The
modified "X" pattern at 7,500 miles is recommended. Also, point out the importance of proper inflation pressure, as listed on the tire
placard on the driver's door edge.

3.

Old tires must be scrapped by drilling four (4) holes through the tire's serial number, located on the back sidewall.

Mount new tires with the yellow mark or orange label on the tire at the valve stem on the wheel. Balance and install on non-drive axle positions.

CUSTOMER REIMBURSEMENT

Claims for customer reimbursement of previously paid repairs due to the described tire wear condition, accompanied by originals of paid receipts
verifying vehicle mileage, should be submitted to the Zone Consumer Relations Office. Vehicle mileage must be within the specified parameters to be

Rear Inner Headliner Roof Molding - Sagging|Page 546 > < Rear Inner Headliner Roof Molding - Sagging|Page 544