Suburban 1/2 Ton 4WD V8-379 6.2L DSL (1986)
NOTE:
Pry the tops of the panel away from the side seal clips.
INSTALL OR CONNECT (see Figures 1-7)
Note:
Check that all the trim retainers are securely fastened, and are not damaged. Replace damaged fasteners.
1.
Clean the area where the seal will be applied with a grease or wax remover.
2.
Install new style seal assembly (see Figure 7).
3.
Install top and lower foam seals (see Figures 1 and 2).
4.
Connect all electrical connections to door trim panel (if equipped with power locks and/or windows).
5.
Install door trim panel onto the door side window seal clips.
6.
Install inside door handle assembly and rod.
7.
Install door trim retainers into the door panel.
8.
Install door trim panel to door screws (22).
9.
Install strap assembly covers (if equipped).
10.
Install strap assembly screws (if equipped).
11.
Install strap assembly (if equipped).
12.
Install arm rest to the door.
13.
Install arm rest to arm rest bracket screws (91).
14.
Install manual door lock knob.
15.
Install window regulator handle.
Warranty Information
For vehicles repaired under warranty use:
Labor Operation
Door
Labor Time
T7056
Right Front
.6 hr.
T7057
Left Front
.6 hr.
T7058
Right Rear
.5 hr.
T7059
Left Rear
.5 hr.
NOTE:
Labor Operation is coded to base vehicle coverage in the warranty system.
FAILURE CODE: 92