Suburban 1/2 Ton 4WD V8-5.3L VIN Z Flex Fuel (2006)
1. Connect the electrical connectors, as necessary.
2. Install the speaker.
3. Install the garnish molding.
4. Install the garnish molding.
5. Verify the component's operation.
Rear Door
SPEAKER REPLACEMENT - REAR DOOR
REMOVAL PROCEDURE
1. Remove the door trim panel.
2. Remove the screws (1) retaining the speaker to the mounting bracket.
3. Disconnect the electrical connector from the speaker.
4. Remove the speaker from the mounting bracket.
5. Remove the bolts (2) retaining the speaker mounting bracket to the door, if required.
6. Remove the speaker mounting bracket.
INSTALLATION PROCEDURE
1. Install the speaker mounting bracket.
2. Install the bolts (2) retaining the speaker mounting bracket to the door, if removed.
Tighten the bolts to 6 N.m (53 lb in).
NOTE: Refer to Fastener Notice in Service Precautions.
3. Install the speaker to the mounting bracket.
4. Connect the electrical connector to the speaker.
5. Install the screws (1) that retain the speaker to the mounting bracket.
Tighten the screws to 2 N.m (53 lb in).
6. Install the door trim panel.
7. Verify the component operation.