Suburban 1/2 Ton 4WD V8-5.3L VIN Z Flex Fuel (2006)
11. Install the base covers.
12. Install the inboard fasteners to the luggage carrier base covers.
Tighten the luggage carrier base cover fasteners to 1.2 N.m (11 lb in).
Luggage Carrier Slats Replacement
LUGGAGE CARRIER SLATS REPLACEMENT
TOOLS REQUIRED
J 25070 Heat Gun
REMOVAL PROCEDURE
1. Mark the location of the luggage carrier slats on the roof with masking tape.
2. Use tape to protect the mounting surface during removal.
3. To remove the luggage carrier slats, heat the slats using J 25070 . Apply heat in a circular motion for 30 seconds
4. Use a plastic, flat-bladed tool to lift or remove the slats from the vehicle.
NOTE: Use a plastic, flat-bladed tool to prevent paint damage when removing an emblem/name plate.
5. Remove the luggage carrier slats from the vehicle.
6. When replacing the slats, remove all of the adhesive using a 3M(tm) Scotch Brite molding adhesive remover disk, 3M(TM) P/N 07501 or
equivalent.
INSTALLATION PROCEDURE
1. Heat the mounting surface to approximately 27-41°C (80-105°F).
IMPORTANT: Apply the slats in an environment that is free from dust or other dirt that could come into contact with the sticky backing. Foreign
material may cause improper adhesion.
2. Ensure that the temperature of the slats is approximately 29-32°C (85-90°F).
3. Remove the backing from the adhesive on the slats.
