Suburban 1/2 Ton 4WD V8-5.3L VIN Z Flex Fuel (2006)
Brake Caliper: Testing and Inspection
Disc Brake Mounting and Hardware Inspection - Rear
Disc Brake Mounting and Hardware Inspection - Rear
Caution: Refer to Brake Dust in Service Precautions.
1. Remove the disc brake caliper from the caliper mounting bracket.
2. Remove the disc brake pads from the caliper mounting bracket.
3. Inspect the disc brake pad mounting hardware for the following:
^
Missing mounting hardware
^
Excessive corrosion
^
Bent mounting tabs
^
Looseness at the caliper mounting bracket
^
Looseness at the disc brake pads
4. If any of the conditions listed are found, the disc brake pad mounting hardware requires replacement.
5. Ensure the disc brake pads are held firmly in place on the caliper mounting bracket, yet slide easily on the mounting hardware without binding.
6. Install the disc brake pads to the caliper mounting bracket.
7. Install the disc brake caliper to the mounting bracket.
