Suburban 1/2 Ton 4WD V8-5.3L VIN Z Flex Fuel (2006)
Disc Brake Backing Plate Replacement - Rear (W/O NYS)
Removal Procedure
Caution: Refer to Brake Dust Caution in Cautions and Notices.
1. Release the park brake.
2. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle.
3. Remove the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation.
4. Relieve the tension from the park brake cable by pulling down on the cable in front of the equalizer and removing the cable from the equalizer bar.
5. Remove the park brake cable from the mounting bracket (4) by depressing the locking tabs.
6. Remove the rear park brake cable end (2) from the park brake actuator lever (1).
7. Remove the rotor.
8. Remove the axle shaft.
9. Remove the park brake shoe.
