Suburban 1/2 Ton 4WD V8-5.3L VIN Z Flex Fuel (2006)
6. Install the brake caliper mounting bracket and brake caliper as an assembly.
Notice: Refer to Fastener Notice in Service Precautions.
7. Install the brake caliper mounting bracket bolts.
Tighten the brake caliper mounting bracket bolts to 300 Nm (221 ft. lbs.).
8. Tighten the brake caliper mounting bolts
Tighten the brake caliper mounting bolts to 108 Nm (80 ft. lbs.).
9. Remove the rubber cap or plug from the exposed brake hose fitting end.
Important: Install 2 new copper brake hose gaskets.
10. Assemble the 2 new copper brake hose gaskets and the brake hose inlet fitting boll to the brake hose.
11. Connect the brake hose at the caliper by installing the brake hose to caliper bolt
Tighten the bolt to 40 Nm (30 ft. lbs.).
12. Bleed the hydraulic brake system. Refer to Hydraulic Brake System Bleeding (Manual) or Hydraulic Brake System Bleeding (Pressure) in
Hydraulic Brakes.
13. Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
14. Lower the vehicle.
15. Fill the master cylinder reservoir to the proper level with clean brake fluid. Refer to Master Cylinder Reservoir Filling in Hydraulic Brakes.
Disc Brake Hardware Replacement - Front
Disc Brake Hardware Replacement - Front
Removal Procedure
Caution: Refer to Brake Dust Caution in Service Precautions.
1. Raise and support the vehicle. Refer to Vehicle Lifting..
2. Remove the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
