Suburban 1/2 Ton 4WD V8-5.3L VIN Z Flex Fuel (2006)
1. Important: Do not use RTV or any other type of sealant on the EBCM gasket or mating surfaces.
Install the EBCM (2) onto BPMV (1).
2. Notice: Refer to Fastener Notice in Service Precautions.
Important: Do not reuse the old mounting bolts. Always install new EBCM bolts with the new BPMV.
Install the four EBCM bolts.
Tighten the 4 bolts to 5 Nm (39 inch lbs.) in an X-pattern.
3. Connect the 2 way ABS pump motor connector to the EBCM.
4. Install the BPMV (1) to EHCU bracket (3).
5. Install the BPMV (1) to bracket retaining bolts (4).
Tighten the bolts to 9 Nm (7 ft. lbs.).
6. Install the EHCU to the vehicle frame (5).
Tighten the three EHCU bracket bolts (4) to 25 Nm (18 ft. lbs.).
7. Connect the 2 electrical harness connectors to the EBCM (1).
8. Important: The brake pipes are held in place by a plastic bracket mounted to the frame. Make sure that the brake pipes stay in the correct place
for proper reassembly.
Install the 5 brake pipes to the BPMV (6).
Tighten the brake pipe fittings to 30 Nm (22 ft. lbs.).
9. Bleed the brake system. Refer to Hydraulic Brake System Bleeding (Manual) Hydraulic Brake System Bleeding (Pressure),
10. Bleed the brake system. Refer to ABS Automated Bleed Procedure (w/o JL4) ABS Automated Bleed Procedure (W/JL4),
