Suburban 1/2 Ton 4WD V8-5.3L VIN Z Flex Fuel (2006)
2. Disconnect the electrical connector (4) from the right air temperature actuator (3).
3. Remove the screws from the right air temperature actuator (3).
4. Remove the right air temperature actuator (3) from the HVAC module assembly (2).
INSTALLATION PROCEDURE
1. Install the right air temperature actuator (3) from the HVAC module assembly (2).
2. Install the screws to the right air temperature actuator (3).
NOTE: Refer to Fastener Notice in Service Precautions.
Tighten the screws to 2 N.m (18 lb in).
3. Connect the electrical connector to the right air temperature actuator.
4. Install the I/P carrier.
5. Reprogram the air temperature actuator. Refer to Re-Calibrating Actuators.
Air Temperature Actuator - Auxiliary
AIR TEMPERATURE ACTUATOR REPLACEMENT - AUXILIARY
REMOVAL PROCEDURE
1. Remove the right rear quarter trim panel.
2. Disconnect the electrical connector from the auxiliary air temperature actuator.
3. Remove the retaining screws from the auxiliary air temperature actuator.
4. Remove the auxiliary air temperature actuator (1) from the rear auxiliary HVAC module.
INSTALLATION PROCEDURE
