Suburban 1/2 Ton 4WD V8-5.3L VIN Z Flex Fuel (2006)
Speed Sensor: Service and Repair
BW 4482-NR4 Transfer Case
Transfer Case Speed Sensor Replacement
Removal Procedure
1. Remove the transfer case shield, if equipped.
2. Disconnect the speed sensor electrical connector (1).
3. Remove the speed sensor and O-ring seal.
Installation Procedure
1. Install the speed sensor with a NEW O-ring seal.
^
Tighten the sensor to 17 Nm (13 ft. lbs.).
Notice: Refer to Fastener Notice in Service Precautions.
