Suburban 1/2 Ton 4WD V8-5.3L VIN Z Flex Fuel (2006)
3. Close the bracket around the upper control arm making sure the bracket rests between the locating stops.
4. Install the bolt.
^
Tighten the bolt to 25 Nm (18 ft. lbs.).
5. Connect the sensor harness connector to the vehicle harness connector.
6. Install the wheel and tire assembly to the vehicle.
25 Series
Rear Position Sensor Replacement - Electronic Suspension - Left (25 Series)
Removal Procedure
1. Raise the vehicle. Refer to Vehicle Lifting.
2. Remove the wheel from the vehicle.
3. Disconnect the sensor harness connector from the vehicle harness connector.
4. Remove the bolts.
5. Remove the position sensor from the vehicle.
6. Disconnect the sensor link from the ball stud.
Installation Procedure
1. Install the position sensor on the vehicle.
2. Install the bolts.
^
Tighten the bolts to 12 Nm (106 inch lbs.).