Suburban 1/2 Ton 4WD V8-5.3L VIN Z Flex Fuel (2006)
Notice: Refer to Fastener Notice in Service Precautions.
3. Connect the sensor link to the ball stud.
4. Connect the sensor harness connector to the vehicle harness connector.
5. Install the wheel to the vehicle.
6. Lower the vehicle.
Rear Position Sensor Replacement - Right
Rear Position Sensor Replacement - Electronic Suspension - Right
Removal Procedure
1. Raise the vehicle. Refer to Vehicle Lifting.
2. Remove the wheel from the vehicle.
3. Disconnect the sensor harness connector from the vehicle harness connector.
4. Disconnect the sensor link from the ball stud.
5. Remove the bolts.
6. Remove the position sensor from the vehicle.
Installation Procedure
1. Install the position sensor on the vehicle.
