Suburban 1/2 Ton 4WD V8-5.3L VIN Z Flex Fuel (2006)
Steering Mounted Controls Transmitter: Service and Repair
Steering Wheel Control Switch Assembly Replacement
Removal Procedure
1. Remove the steering wheel.
2. Remove the shroud retaining screws from the back of the steering wheel.
3. Remove the shroud from the steering wheel.
4. Position a blunt ended tool into the wire harness cavity (1) and apply moderate pressure in order to partially remove the steering wheel control
switch from the steering wheel.
5. Disconnect the steering wheel control switch electrical connector.
6. Important: The bulbs in the steering wheel control switches are not serviceable. The switches should be replaced only as an assembly.
Remove the steering wheel control switch from the steering wheel.
Installation Procedure
1. Position the steering wheel control switch to the steering wheel.
2. Connect the electrical connector to the steering wheel control switch.
3. Install the steering wheel control switch into the steering wheel, ensuring the retaining tabs are fully seated.
