Suburban 1/2 Ton 4WD V8-5.3L VIN Z Flex Fuel (2006)
Tie Rod: Service and Repair
Front Steering
Inner
Tie Rod Replacement - Inner
^
Tools Required
-
J 34028 Inner Tie Rod Wrench
Removal Procedure
1. Raise the vehicle.
2. Remove the engine protection shield, if equipped.
3. Remove the outer tie rod end.
4. Remove the inner tie rod end using the -1 34028 (2).
Installation Procedure
Important: Perform the following procedure before installing the new tie rod ends:
1. Remove all traces of the oil, grease, or other contaminants.
2. Clean the threads of the tie rod with denatured alcohol or the equivalent and allow to dry.
3. Apply red LOCTITE Threadlocker, GM P/N 12345493 (Canadian P/N 10953488) to the threads of the inner tie rod.
Notice: Refer to Fastener Notice in Cautions and Notices.
4. Install the inner tie rod to the relay rod.
^
Using the J 34028 (2) tighten the tie rod to 100 Nm (74 ft. lbs.).
5. Install the outer tie rod end.
