Suburban 1/2 Ton 4WD V8-5.3L VIN Z Flex Fuel (2006)
1. Raise and support the vehicle.
2. Support the rear axle.
3. Disconnect the electronic suspension control (ESC) electrical connector at the pigtail connector left side only, if equipped.
4. Disconnect the ESC electrical connector at the top of the right side shock, if equipped.
5. Disconnect the ESC sensor, if equipped.
6. Remove the upper shock absorber nut and the bolt.
7. Remove the lower shock absorber nut and the bolt.
8. Remove the shock absorber.
Installation Procedure
1. Install the shock absorber.
2. Install the upper shock absorber nut and bolt.