Suburban 2WD V8-6.0L (2007)
^
If removing and installing the original brake pads and retaining springs, reference mark the position of the brake pads and retaining springs
for proper installation.
^
DO NOT re-use the old brake pad retaining springs with new brake pads. Replace with NEW only.
Remove the brake pads (3) and retaining springs (4) from the mounting bracket (5).
Installation Procedure
1. Install the retaining springs (4) on the caliper mounting bracket (5).
2. Install the brake pads (3).
^
Install the new brake pads.
^
Install the original brake pads in their original position.
3. Remove the mechanics wire and rotate the brake caliper (2) into position on the mounting bracket (5).
4. Install NEW caliper guide pin bolts.
Important:
^
DO NOT use any air tools to remove or tighten the guide pin bolts. Use hand tools ONLY.
