Suburban 2WD V8-6.0L (2007)
3. Install the caliper to the caliper bracket.
Notice: Refer to Fastener Notice.
4. Install the brake caliper bolts.
Tighten the bolts to 108 N.m (80 lb ft).
5. Install the tire and wheel assembly.
6. Lower the vehicle.
7. With the engine OFF, gradually apply the brake pedal to approximately 2/3 of its travel distance.
8. Slowly release the brake pedal.
9. Wait 15 seconds, then repeat steps 7-8 until a firm pedal is obtained, to properly seat the brake caliper pistons and brake pads.
10. Fill the master cylinder reservoir to the proper level with clean brake fluid, if necessary. Refer to Master Cylinder Reservoir Filling.
11. Burnish the pads and rotors. Refer to Brake Pad and Rotor Burnishing.
