Suburban 2WD V8-6.0L (2007)
Ignition Lock: Service and Repair
Ignition Lock Cylinder Case Replacement
Ignition Lock Cylinder Case Replacement
Removal Procedure
Caution: Disable the SIR system.
1. Remove the inflatable restraint steering wheel module coil.
2. Remove the ignition/start switch.
3. Remove the park lock cable from the lock cylinder housing.
4. Disconnect the passlock and key buzzer from the ignition lock cylinder case.
5. Remove the 3 ignition lock cylinder case screws (2).
6. Remove the ignition lock cylinder case (1) from the vehicle.
Installation Procedure