Suburban 3/4 Ton 4WD V8-393 6.5L DSL Turbo (1993)
Body Control Module: Technical Service Bulletins
PCM & BCM (W/Mylar Strips) - Servicing
Number: 93-62-6E
Section: 6E
Date: NOV. 1992
Corporate Bulletin No.: 216106
ASE No.: A6
Subject:
SERVICING POWERTRAIN CONTROL MODULE (PCM) AND BODY COMPUTER MODULE (BCM) WITH MYLAR STRIPS
Model and Year:
1993 ALL PASSENGER CARS AND TRUCKS
In a continuing effort to improve the quality of our products, new PCM's and BCM's are being built with mylar strips inserted in each connector. This
mylar strip reduces the potential for bending connector pins when the PCM or BCM is connected to the wiring harness. As the harness is connected to
the PCM or BCM, this mylar strip is pushed to the back of the connector. The service units you receive may have the mylar strips pushed back or at the
front edge of the connector.
Here are two special guidelines to observe when you notice these mylar strips:
^
Do not attempt to pull out the mylar strips to the front edge of the connector. Due care when servicing these units will prevent bent pins.
^
Do not attempt to remove the mylar strips even if they are damaged. There is enough clearance at the back of the connector for one mylar strip.
