Suburban 3/4 Ton 4WD V8-393 6.5L DSL Turbo (1993)
Installing Clutch Plate & Hub Assembly
4. Install the Clutch Plate and Hub Installer J 9401-B.
5. Hold the hex portion of the Installer Body J 9401-B with a wrench and tighten the center screw to press the hub onto the shaft until there is a
0.5-7.6mm (0.020-0.030") air gap between the frictional surfaces of the clutch plate and clutch rotor.
6. If operation is performed with compressor on vehicle, connect drive belt, tighten mounting brackets and adjust belt tension.
