Suburban 3/4 Ton 4WD V8-393 6.5L DSL Turbo (1993)
Door Module
Remove or Disconnect
1. Door trim panel. Refer to Door Trim Panel. See: Body and Frame/Doors, Hood and Trunk/Doors
^
Lower the window all the way.
2. Screws holding the module to the door (88).
^
Pull back the water deflector.
3. Lock and handle rods from the back of the module.
^
Tape them to the door.
4. Module wiring connector (if present).
A. Pull the wiring from the door hinge pillar to reach the connector.
B. Remove the boot over the wiring.
C. Push the wiring harness into the door.
5. Upper belt through window run channel.
A. Move the channel away from the glass.
B. Tilt the module and window glass assembly, then lift it out of the bottom of the door.
Install or Connect
1. Module and glass assembly into the door.
^
Fit the glass into the rear channel inside the door.
2. Upper run channel bolt and tighten it.
3. Lock and handle rods to the back of the module.
4. Wiring connector (if present).