Suburban 3/4 Ton 4WD V8-6.0L VIN U (2004)
1. Install the inner tie rod to the steering gear.
Notice: Refer to Fastener Notice in Cautions and Notices.
2. Using the J 44665-2 (2) tighten the inner tie rod (1).
^
Tighten the inner tie rod to 100 Nm (74 ft. lbs.).
3. Install the inner tie rod support clamp to the steering gear. Use the J44665-1 (1) and the J 44665-2 (2) in order to tighten the inner tie rod support
clamp.
^
Tighten the inner tie rod support clamp to 25 Nm (18 ft. lbs.).
4. Install the rack and pinion boot to the steering gear.
5. Install the tire and wheel.
6. Lower the vehicle.
7. Perform a four wheel alignment.
Outer
Rear Wheel Steering Tie Rod End Replacement - Outer
^
Tools Required
-
J 24319-B Universal Steering Linkage Puller
Removal Procedure