Suburban 4WD V8-6.0L (2007)
-
The crankshaft front oil seal MUST be centered in relation to the crankshaft.
-
An improperly aligned front cover may cause premature front oil seal wear and/or engine oil leaks.
1. If replacing the front cover perform the following steps, otherwise proceed to step 10.
2. Install a NEW CMP actuator magnet gasket (753) onto the magnet.
Notice: Refer to Fastener Notice.
3. Install the CMP actuator magnet (752) and bolts (751).
Tighten the bolts to 12 N.m (106 lb in).
4. Inspect the CMP sensor O-ring seal for cuts or damage. If the seal is not cut or damaged, it may be reused.
5. Lubricate the O-ring seal (704) with clean engine oil.
