Suburban 4WD V8-6.0L (2007)
Camshaft Position Sensor: Service and Repair
Camshaft Position Sensor Replacement (With RPO Codes LY2/LC9/LY5/LMG)
CAMSHAFT POSITION SENSOR REPLACEMENT (WITH RPO CODES LY2/LC9/LY5/LMG)
REMOVAL PROCEDURE
IMPORTANT: Clean the area around the camshaft position (CMP) sensor before removal in order to prevent debris from entering the engine.
1. Raise and support the vehicle. Refer to Vehicle Lifting.
2. Disconnect the engine wiring harness electrical connector (1) from the CMP sensor wire harness.
3. Remove the CMP sensor wire harness bolts (705, and 738).
4. Remove the CMP sensor wire harness (737).
5. Remove the CMP sensor (703) and O-ring seal (704).
