Suburban 4WD V8-6.0L (2007)
INSTALLATION PROCEDURE
1. Inspect the CMP O-ring seal for cuts or damage. If the seal is not cut or damaged, it may be used again.
2. Lubricate the O-ring seal with clean engine oil.
3. Install the O-ring seal (704) onto the sensor.
4. Instal the CMP sensor (703) to the front cover.
5. Install the CMP sensor wire harness (737).
6. NOTE: Refer to Fastener notice.
Install the CMP sensor wire harness bolts (705, and 738).
Tighten the bolts to 12 N.m (106 lb in).
7. Connect the engine wiring harness electrical connector (1) to the CMP sensor wire harness.
