Suburban 4WD V8-6.0L (2007)
Speed Sensor: Service and Repair
Transfer Case Rear Output Shaft Speed Sensor Replacement - Right Side
Transfer Case Rear Output Shaft Speed Sensor Replacement - Right Side
Removal Procedure
1. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle.
2. Disconnect the right rear speed sensor electrical connector (3).
3. Remove the right rear speed sensor.
Installation Procedure
Notice: Refer to Fastener Notice.
1. Install the right rear speed sensor.
Tighten the speed sensor to 15 N.m (11 lb ft).