Suburban 4WD V8-6.0L (2007)
Fluid - Transfer Case: Service and Repair
NVG 246-NP8 - Transfer Case
Transfer Case Fluid Replacement
Removal Procedure
Important: When performing the following procedures, use only hand tools to remove and install the drain and fill plugs.
1. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle.
2. Remove the transfer case shield, if equipped.
3. Remove the fill plug.
4. Remove the drain plug.
Installation Procedure
Notice: Refer to Fastener Notice.
Important: Use only drain and fill plugs that are made from aluminum. Steel or brass plugs are not compatible with the magnesium case.
1. Install the drain plug.
Tighten the plug to 20 N.m (15 lb ft).
2. Fill the transfer case to the bottom of the fill plug hole with Auto-Trak II, transfer case fluid, GM P/N 12378508 (Canadian P/N 10953626).
