Suburban 4WD V8-6.0L (2007)
1. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle.
2. Remove the transfer case shield, if equipped.
3. Remove the rear propeller shaft.
4. Remove the rear output shaft seal by prying it out with a flat tipped screwdriver.
Installation Procedure
1. Using the J 45756, install a NEW front output shaft seal.
2. Install the rear propeller shaft.
3. Check the fluid level. Add fluid, if necessary.
4. Install the transfer case shield, if equipped.
5. Lower the vehicle.
Transfer Case Input Shaft Seal Replacement
Transfer Case Input Shaft Seal Replacement