Suburban 4WD V8-6.0L (2007)
1. Lubricate the input speed sensor seal with automatic transmission fluid.
2. Install the input speed sensor (1).
Notice: Refer to Fastener Notice.
3. Install the input speed sensor bolt.
Tighten the bolt to 11 N.m (96 lb in).
4. Connect the input speed sensor electrical connector (2).
5. Lower the vehicle.
Output Shaft Speed Sensor Replacement
Output Shaft Speed Sensor Replacement
Removal Procedure
Important: This procedure is for 2-wheel drive (2WD) vehicles only. If the vehicle is equipped with 4-wheel drive (4WD), the output speed
sensor is located on the transfer case.
1. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle.