Tahoe 2WD V8-4.8L VIN V (2004)
1. Ensure the bottom of the molding is seated in the slots on the I/P.
2. Align the molding retainers to the slots.
3. Press the moldings straight in till fully seated.
Trim Panel Replacement - Front Seat
TRIM PANEL REPLACEMENT - FRONT SEAT
REMOVAL PROCEDURE
1. Ensure the seat is in the full upward position.
2. Remove the screws retaining the seat back release handle and the seat recliner handle, if equipped.
3. Remove the trim panel (1) by pulling outward in order to disengage the retaining clip.
4. Remove the trim panel from the seat.
INSTALLATION PROCEDURE
1. Position the trim panel on the seat from the front to the back.
NOTE: Refer to Fastener Notice in Service Precautions.
2. Instal the trim panel (1) to the seat by pushing in until the retaining clips are locked in place.
3. Install the screws retaining the seat back release handle and the seat recliner handle to the seat, if removed.
Tighten the screws to 2 N.m (18 lb in).
Trim Panel Replacement - Hinge Pillar
Trim Panel Replacement - Hinge Pillar
Removal Procedure
