Tahoe 2WD V8-4.8L VIN V (2004)
16. Adjust the accelerator pedal to the fully forward position using the following procedure.
1. Remove the screws from cable housing at the top of the adjustable pedal motor.
2. Twist the cable housing to unlock the cable from the motor.
3. Remove the cable from the adjustable pedal motor.
4. Attach a drill motor or equivalent to the adjustable pedal cable.
5. Spin the cable until there is a distance of 21.4 mm (0.84 in) from the accelerator transmission assembly cap to the small outer diameter of the
adjuster pin.
IMPORTANT: Accurate measurement and adjustment of the following step is critical to ensure the proper step over distance between the brake and
accelerator pedals.
17. Remove the adjustable pedal cable from the accelerator pedal:
0. Twist the cable housing to unlock the cable from the accelerator pedal.
1. Compress the secondary locking tabs located below the housing locking tabs and pull the cable from the accelerator pedal assembly.
18. Remove the nut from the brake pedal pivot bolt.
