Tahoe 2WD V8-4.8L VIN V (2004)
IMPORTANT: Note the position of the brake pedal return spring (1).
19. Remove the brake pedal pivot bolt.
20. Remove the brake pedal and return spring assembly from the bracket.
INSTALLATION PROCEDURE
1. Install the brake pedal and return spring assembly to the bracket.
2. Install the brake pedal pivot bolt.
3. Install the nut to the brake pedal pivot bolt.
NOTE: Refer to Fastener Notice in Service Precautions.
Tighten the nut to 30 N.m (22 lb ft).
4. Hook the return spring (1) to the backside of the brake pedal assembly (2).
5. Install the adjustable pedal cable to the accelerator pedal:
1. Insert the adjustable cable into the accelerator pedal assembly until it is secured by the secondary locking tabs.
2. Install and twist the cable housing to secure to the accelerator pedal assembly.
IMPORTANT: The adjustable pedals cable assembly must be installed in its original position and fastened with cable retaining clip to the top of the
bracket. Make sure the cable is not twisted or binding.
