Tahoe 2WD V8-4.8L VIN V (2004)
7. Install the cable at the shock absorber bracket and install the bolt.
Tighten the bolt to 25 Nm (18 ft. lbs.).
8. Install the cable to the mounting bracket until the locking tabs snap into place.
9. Install the park brake cable to the equalizer bar by pulling down on the cable in front of the equalizer and installing the cable to the equalizer bar.
10. Remove the safety stands.
11. Lower the vehicle.
12. Adjust the park brake cable. Refer to Park Brake Adjustment.
(With RPO Nys)
Park Brake Cable Replacement - Left Rear (with RPO NYS)
Removal Procedure
1. Release the park brake.
2. Raise and support the vehicle. Refer to Vehicle Lifting..
3. Remove the park brake cable from the equalizer by pulling down on the intermediate cable and release the cable from the equalizer bar.
