Tahoe 2WD V8-4.8L VIN V (2004)
6. Attach the cable to the lever.
7. Install the cable to the track bar and secure with the clips. Verify that the clips are installed between the locators on the track bar (15 series).
8. Install the cable to the right and left side guides.
9. Install the cable to the mounting bracket until the locking tabs snap into place.
Notice: Refer to Fastener Notice in Service Precautions.
10. Bolt the cable to the differential (clips).
Tighten the bolt to 25 Nm (18 ft. lbs.).
Important: After installing the cable to the rear axle holding clip, verify that clip is securely retaining the cable. If not, crimp the clip by hand taking
care not to pinch or kink the cable.
11. Install the cable to the differential clip.
