Tahoe 2WD V8-4.8L VIN V (2004)
Notice: Refer to Fastener Notice in Service Precautions.
5. Install the WSS mounting bolt.
Tighten the WSS mounting bolt to 18 Nm (13 ft. lbs.).
6. Install the WSS cable mounting clip to the knuckle.
7. Install the WSS cable mounting clip to the upper control arm.
8. Install the WSS cable mounting clip to tile fame attachment point.
9. Connect the WSS cable electrical connector
10. Install the brake rotor (2) shown on the 1500 series. Refer to Brake Rotor Replacement -Front in Disc Brakes.
11. Install the tire and wheel. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
