Tahoe 2WD V8-4.8L VIN V (2004)
15. Position the heater inlet hose clamp at the water pump.
16. Remove the heater inlet hose from the water pump.
17. Remove the water pump bolts.
18. Remove the water pump and gaskets.
19. Discard the water pump gaskets.
Installation Procedure
Important: All gaskets surfaces are to be free of oil or other foreign material during assembly.
1. Install the water pump and NEW gaskets.
Notice: Refer to Fastener Notice in Service Precautions.
2. Install the water pump bolts.
2.1.
Tighten the bolts a first pass to 15 Nm (11 ft. lbs.).
