Tahoe 2WD V8-4.8L VIN V (2004)
Important: Do not reuse the old mounting screws. Always install new mounting screws with the new EBCM.
Important: Do not use RTV or any other type of sealant on the EBCM gasket or mating surfaces.
1. Install the EBCM(2) on to the BPMV(1).
Notice: Refer to Fastener Notice in Service Precautions.
2. Install the four new screws in the EBCM(2).
Tighten the four screws to 5 Nm (39 inch lbs.) in an X-pattern.
3. Install or tighten three EHCU bracket mounting bolts (4).
Tighten the EHCU bracket mounting bolts to 25 Nm (18 ft. lbs.).
4. Connect the electrical connectors to the EBCM (1).
5. Lower the vehicle.
6. Connect the negative battery cable.
7. Revise the tire calibration using the Scan Tool Tire Size Calibration function.
8. Return to Diagnostic Starting Point - Antilock Brake System.
