Tahoe 2WD V8-4.8L VIN V (2004)
4. Position the J41364-A onto the PNP switch. Ensure that the two slots on the switch where the manual shaft is inserted are lined up with the lower
two tabs on the tool.
Notice: Refer to Fastener Notice in Service Precautions.
5. Rotate J41364-A until the upper locator pin on the tool is lined up with the slot on the top of the switch.
^
Tighten the bolts to 25 Nm (18 ft. lbs.).
6. Remove J 41364-A from the PNP switch. If installing a new switch, remove the positive assurance bracket at this time.
7. Install the control lever to the manual shaft with the nut.
8. Install the manual shaft nut.
^
Tighten the nut to 25 Nm (18 ft. lbs.).
9. Install the range selector cable end (2) to the range selector lever ball stud (1).
