Tahoe 2WD V8-4.8L VIN V (2004)
4. Using a wide plastic flat-bladed tool, release the retaining clips on both sides of the door module.
5. Remove the door module from the switch panel bezel.
INSTALLATION PROCEDURE
1. Install the door module into the switch panel bezel until it snaps into place.
2. Install the switch panel bezel and module into the door trim panel.
3. Install the screw (2) that retains the switch panel bezel (1) to the front door trim panel.
NOTE: Refer to Fastener Notice in Service Precautions.
Tighten the screw (2) to 2 N.m (18 lb in).
4. Install the front door trim panel.
5. Perform the programming procedure for the Tire Pressure Monitoring system. Refer to Control Module Setup in Tire Pressure Monitoring.
