Tahoe 2WD V8-4.8L VIN V (2004)
Tighten the nut to 3.4 N.m (30 lb in).
7. Position the starter into place.
8. Install the starter bolts.
Tighten the bolts to 50 N.m (37 lb ft).
9. Connect the oil level sensor electrical connector.
10. If equipped with 4WD, position the front axle mounting bracket bolt until the bolt is fully seated.
11. If equipped with 4WD, install the front axle mounting bracket nuts.
Tighten the nuts to 95 N.m (70 lb ft).
12. Install the transmission cover bolt.
Tighten the bolt to 9 N.m (80 lb in).
13. Lower the vehicle.
14. Connect the negative battery cable.
