Tahoe 2WD V8-4.8L VIN V (2004)
^
Tighten the upper control arm retaining nut to 50 Nm (37 ft. lbs.).
6. Install the brake hose and the bracket retaining bolt to the steering knuckle
^
Tighten the bolt to 9 Nm (80 inch lbs.).
7. Install the outer tie rod to the steering knuckle.
8. Install the wheel hub and bearing assembly.
9. Connect the ESC link rod to the sensor, if equipped.
10. Install the tire and wheel.
11. Load the torsion bars.
12. Remove the safety stands.
13. Lower the vehicle.
14. Check the wheel alignment.
