Tahoe 2WD V8-4.8L VIN V (2004)
1. Install the shock absorber.
2. Install the upper shock absorber nut and bolt.
Notice: Refer to Fastener Notice in Cautions and Notices.
3. Install the lower shock absorber nut and bolt.
^
Tighten the upper and lower shock absorber nuts to 95 Nm (70 ft. lbs.).
4. Connect the electrical connector and air line if equipped with RTD.
5. Connect the ESC sensor, if equipped.
6. Remove the support from the rear axle.
7. Remove the safety stands.
8. Lower the vehicle.
