Tahoe 2WD V8-4.8L VIN V (2004)
1. Install the pawl shaft.
2. Install the parking pawl.
3. Install the plug using a 8 mm or (5/16 inch) rod with Loctite(R) or equivalent.
4. Install the retainer.
5. Install the pawl return spring.
6. Install the detent lever to the actuator.
7. Install the actuator over the parking pawl.
8. Install the manual shaft seal.
9. Lubricate the manual shaft with transmission oil and install the manual shaft into the case.
10. Install the nut on the shaft.
11. Install the roll pin.
Notice: Refer to Fastener Notice in Service Precautions.
12. Install the parking lock bracket bolts.
^
Tighten the bolts to 24 Nm (18 ft. lbs.).
13. Install the PNP switch. Refer to Park/Neutral Position Switch Replacement.
14. Install the transmission filter.
15. Fill the transmission to the proper level with Dexron-III transmission fluid. Refer to Transmission Fluid Checking Procedure.
