Tahoe 2WD V8-4.8L VIN V (2004)
wick up the strands of the wire and may corrode other components/connections.
9.
Slide one end of the new wire through the weather pack seal that was removed from the old wire.
10.
Properly attach the 12077411 terminal (crimp and solder) to one end of the new black wire.
11.
Properly attach a 12103507 ring terminal (crimp and solder) to the other end of the new black wire.
12.
Place the new terminal and wire assembly into the rear washer pump connector and properly position the weather pack seal.
13.
Reconnect the connector to the rear washer pump.
14.
Route the new black wire down to the attaching point on the frame, same location as the battery ground. Follow the battery cable routing.
15.
Remove the ground to frame attaching bolt.
16.
Clean the battery cable and G100 ring terminals of contamination.
17.
Install the new wire ring terminal between the battery ground wire (5) and the existing G100 ground wire (3).
Tighten
Tighten the engine wiring harness ground/negative cable bolt to 25 N.m (18 lb ft).
18.
Install the lower washer bottle retaining bolt.
Tighten
Tighten the bolt to 9 N.m (80 lb in).
19.
Lower the vehicle.
20.
Install the upper washer bottle retaining bolt.
Tighten
Tighten the bolt to 9 N.m (80 lb in).
21.
Install the battery tray.
Tighten
