Tahoe 2WD V8-5.3L (2007)
2. Apply approved anti-corrosion primer to the bare metal surfaces.
3. Insert the sleeve (1) into the rail end as shown. Align the sleeve with the holes drilled in the previous step.
Important: The bolt plate must be inserted from the outboard side of the rail toward the inboard side.
4. Install the replacement bumper bracket with the supplied bolt plate (1).
5. Hand tighten the fasteners.
6. Install all related panels and components.
7. Align the front bumper assembly.
Notice: Refer to Fastener Notice .
8. Tighten the bolts.
Tighten the bolts to 160 N.m (118 lb ft).
